U bent niet ingelogd.

Yuminashi/RZR Performance Pack 1.2.1 Honda MSX 125

Snel overzicht

This kit consists of the Yuminashi Light Bore Injector MSX 125 and the K&N R1100 and the all stainless steel front pipe with 25mm inner diameter to be used in combination with the stock silencer.
With the rigt set-up this kit will boost top-speed to 117km/h

Beschikbaarheid: In voorraad

€ 234,50

Meer afbeeldingen


K&N Universal Air Filters K&N's Universal Air Filters are designed and manufactured for a wide variety of applications. Regardless of the angle, offset diameter of the air intake, there is a K&N Universal air filter for your equipment. All filters are constructed with ultra-strong molded pliable rubber flanges which absorb vibration and allow for secure attachment and can also be stretched for up to 1/16" (1.5mm) to fit in-between sizes. K&N Universal air filters are available in round, tapered (cone style) and oval designs, for just about any special application. Select a universal filter type below to view the sizes that are available. This Light Bore High Performance Fuel Injector looks exactly the same as your genuine MSX125 fuel injector, and you only can see, or better said, feel, the difference once you have installed it on your MSX125 in combination with the Yuminashi 145cc Light Bore Piston set (to bore your genuine 125cc cylinder up to 145cc), or with the full 150cc light bore cylinder kit. This injector is not mentioned to be installed in the 31mm throttle body, but very simply to replace your genuine 125cc injector in your genuine 125cc manifold. Like this you don't need to buy any electronic device for your PGM-FI to upgrade your stock 125cc until a light bore 145cc or 150cc. If you install this injector in your bike, then keep in mind that your ECU must get used to it. Normally its will take 5 to 10Km until your computer will be auto-adjusted to the new injector. *Keep also in mind that the genuine MSX/GROM air filter box is a serious restrictor which will make it almost impossible to make more as 8.000RPM's. If you install our Light bore fuel injector in combination with an original K&N filter or a stack on your genuine 25mm PGM-FI throttle body, then your engine will have no issue with breathing above the 8.000RPM's with the 143cc/150cc Light Bore Kits. **You can use the Light Bore High Performance Fuel Injector on a full stock engine, but we recommend to change at least the 34T rear sprocket in to a 36T rear sprocket. Your engine will be able to make more RPM's with the new injector, but because the overdrive on the genuine 4th gear is such a large overdrive (24/26 gear sprockets), you need to make at least your final drive combination lighter. Our maximum top speed with this setup in perfect conditions without any headwind on a full stock engine and a stock exhaust system was 117Km/h (8.750RPM) and 127Km/h (9.500RPM) with a special exhaust system. Please notice that these results are impossible to gain with a normal straight-up driving position or with the slightest bit of wind because of the large 4th gear overdrive. **Keep in mind that the first step, before you start to tune your engine up with a light bore kit, big bore kit or super bore kit, should be changing the MSX125/GROM's large overdrive characteristic (24/26T - 0.923) in to a mild overdrive or even in to a sports gear. Ask your Yuminashi dealer for sprocket set 23471-K26-025 to turn your 4th gear in to a mild overdrive (24/25 - 0.960). You don't need to change your genuine 34T rear sprocket once the 25T gear sprocket is installed. All Stainless front pipe for Honda MSX, to be used in combination with the stock silencer. Internal bore of 25 mm makes sure your engine has no trouble to breathe with the Yuminashi 150cc light bore kit or the 180cc big bore kit.

Gebruik spaties om tags te scheiden. Gebruik enkele aanhalingstekens (‘) voor woordgroepen.

Schrijf uw eigen review

You're reviewing: Yuminashi/RZR Performance Pack 1.2.1 Honda MSX 125